TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 1262 of 1558
TM 9-2320-366-20-4 16-192 Change 2 16-26. LATCH AND CAB LATCH BRACKETS REPLACEMENT This task covers: a. Latch Bracket Removal b. Latch Bracket Installation c. Cab Latch Bracket Removal d. Cab Latch Bracket Installation INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Cab Support Tool (Item E-4, Appendix E) Materials/Parts Sealing Compound (Item 55.2, Appendix D) Nuts, Self-Locking (2) (Item 168, Appendix G) Personnel Required (2) a. Latch Bracket Removal. (1) Raise cab (TM 9-2320-366-10-1). (2) Install cab support tool on engine rear lifting eye (1). (3) Lower cab until cab rests on cab support tool (TM 9-2320-366-10-1). (4) Remove three bolts (2) and washers (3) from latch bracket (4). NOTE Perform step (5) on vehicles 0001 through 7167. (5) Remove two self-locking nuts (5), screws (6),spacers (7), washers (8), and latch bracket (4) from cab (9). Discard self-locking nuts and spacers. NOTE Perform step (6) on vehicles 7168 and higher. (6) Remove two self-locking nuts (5), screws (6), washers (8), and latch bracket (4) from cab (9). Discard self-locking nuts.