TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 1162 of 1558
TM 9-2320-366-20-4 16-11. FENDER AND SPLASH GUARD REPLACEMENT (CONT) (3) Install nut (6) on hook (7). (4) Position rear splash guard (8) on bracket (1) with hook (7), washer (9), plate (10), washer (11), and nut (12). (5) Position two screws (13), washers (14), and nuts (15) on bracket (1). (6) Tighten nut (12) and two nuts (15) to 18-22 lb-ft (24-30 N·m). g. M1084 Rear Splash Guard Removal. NOTE Left and right rear splash guards are removed the same way. Right side shown. (1) Remove three nuts (1), washers (2), spacers (3), rods (4), and rear splash guard (5) from bumper (6) and fender (7). (2) Remove three nuts (8) from rods (4). h. M1084 Rear Splash Guard Installation. NOTE Left and right rear splash guards are installed the same way. Right side shown. (1) Position three nuts (1) on rods (2). (2) Position rear splash guard (3) between fender (4) and bumper (5) with three rods (2), spacers (6), washers (7), and nuts (8). (3) Tighten three nuts (8) to 18-22 lb-ft (24-30 N·m). 16-94 Change 1