TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 1119 of 1558
TM 9-2320-366-20-4 Change 2 16-55 (3) Position door (7) on cab with hinge (1) in slot in forward edge of door and bolt holes aligned with openings in door. (4) Position door (7) on hinge (1) with three washers (8) and screws (9). (5) Position door (7) on hinge (4) with three washers (10) and screws (11). (6) Position door (7) so that gap between door and cab is approximately equal all around. (7) Tighten three screws (9) and screws (11) one-half turn. (8) Open, close, and open door (7) to ensure correct operation. (9) Tighten three screws (9) and screws (11) to 22-26 lb-ft (30-35 N•m). (9.1) Apply grease to hinges (1 and 4). (10) Install four clip nuts (12) on door (7). (11) Install wiring harness (13) through access hole in forward edge of door (7). NOTE Steps (3) through (7) require the aid of an assistant.