TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 1040 of 1558
TM 9-2320-366-20-4 15-2.2 Change 2 16-5. RESILIENT MOUNT AND MECHANICAL STOP REPLACEMENT (CONT) e. Front Angle Bracket Resilient Mount Removal. Remove nut (1), spring washer (2), bolt (3), and resilient mount (4) from front angle bracket (5). Discard spring washer. f. Front Angle Bracket Resilient Mount Installation. (1) Position resilient mount (4) on front angle bracket (5) with bolt (3), spring washer (2), and nut (1). (2) Tighten nut (1) to 35-46 lb-ft (47-63 N•m). g. Front Leaf Spring Resilient Mount Removal (1) Install C-Clamp on leaf spring (1) (2) Remove resilient mount (2) and spacer (3) from bolt (4). WARNING NOTE Left and right side front angle bracket resilient mounts are removed the same way. Right side shown. NOTE Left and right side front angle bracket resilient mounts are installed the same way. Right side shown. Use care when removing resilient mount from leaf spring. Spring is under tension and can act as a projectile if released. Failure to comply may result in injury to personnel or damage to equipment, NOTE If vehicle has resilient mounts attached with screws and washers, notify DS to install four kits P/N 57K2003 on vehicle.