TM-9-2320-366-20-4 MTV Unit Maintenance Manual M1083 Series - Volume 4 Download
Page 1038 of 1558
TM 9-2320-366-20-4 Section II. MAINTENANCE PROCEDURES 15-2. RESILIENT MOUNT AND MECHANICAL STOP REPLACEMENT This task covers: a. Mechanical Stop Removal b. Mechanical Stop Installation c. Resilient Mount Removal d. Resilient Mount Installation e. Front Angle Bracket Resilient Mount Removal f. Front Angle Bracket Resilient Mount Installation g. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Cab raised (for front angle bracket resilient mount) (TM 9-2320-366-10-1). Tools and Special Tools Goggles, Industrial (Item 15, Appendix C) Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Tools and Special Tools (Cont) Crowfoot Attachment, Socket Wrench (Item 5, Appendix B) Vise, Machinist (Item 48, Appendix C) Materials/Parts Nut, Self-Locking (2) (Item 161, Appendix G) Washer, Spring (Item 287, Appendix G) Washer, Spring (Item 293, Appendix G) WARNING Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. a. Mechanical Stop Removal. NOTE Both mechanical stops are removed the same way. Right rear side shown. Remove two self-locking nuts (1), bolts (2), and mechanical stop (3) from frame (4). Discard self-locking nuts. b. Mechanical Stop Installation. NOTE Both mechanical stops are installed the same way. Right rear side shown. (1) Position mechanical stop (3) on frame (4) with two bolts (2) and self-locking nuts (1). (2) Tighten two self-locking nuts (1) to 118-148 lb-ft (160-201 N·m). 15-2