TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 992 of 1396
TM 9-2320-366-20-3 7-42. M1088/M1089 STATIONARY WORKLIGHT ASSEMBLY REPLACEMENT/REPAIR This task covers: a. Removal b. Disassembly c. Assembly d. Installation e. Follow-On Maintenance INITIAL SETUP Equipment Conditions Batteries disconnected (para 7-57). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Materials/Parts Lockwasher (Item 96, Appendix G) a. Removal. NOTE Left side and right side stationary worklight assemblies are removed the same way. Right side shown. (1) Disconnect worklight connector (1) from connector P134A (2). (2) Remove nut (3), lockwasher (4), washer (5) and worklight assembly (6) from vehicle. Discard lockwasher. b. Disassembly. (1) Remove screw (1) and retaining ring (2) from worklight assembly (3). (2) Loosen two screws (4) on back of lamp (5). (3) Disconnect two terminals (6) from lamp (5). 7-240