TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 972 of 1396
TM 9-2320-366-20-3 CAUTION Do not let wires slip through hole and into cab structure. If wires slip into cab structure, vehicle will need further disassembly to retrieve wires. (5) Disconnect marker light connector (9) from connector P50 (10). (6) Remove nut (11), lockwasher (12), terminal lug (13), lockwasher (14), base (3), and gasket (15) from vehicle. Discard lockwashers. (7) Remove nut (16), and screw (17) from base (3). b. Cab Clearance and Marker Light Installation. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well- ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (1) Apply adhesive to threads of screw (1). (2) Install screw (1) in base (2) with nut (3). NOTE Clearance and marker lights originally come with cork gaskets. Discard cork gaskets and replace with rubber gaskets PN 12421469. (3) Install gasket (4) on base (2). (4) Connect marker light connector (5) to connector P50 (6). (5) Install lockwasher (7), terminal lug (8), lockwasher (9), and nut (10) on back of base (2). 7-220 Change 1 7-38. CLEARANCE AND MARKER LIGHT ASSEMBLIES REPLACEMENT (CONT)