TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 954 of 1396
TM 9-2320-366-20-3 7-34. M1089 WRECKER CONTROL PANEL TOGGLE SWITCH REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Batteries disconnected (para 7-57). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Tool Kit, Electrical (Item 45, Appendix C) Heater, Gun Type, Electric (Item 24, Appendix B) Material/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Insulation Sleeving, Electrical (Item 29, Appendix D) Lockwasher (8) (Item 100, Appendix G) Lockwasher (Item 74, Appendix G) Nut, Self-Locking (2) (Item 134, Appendix G) Splice, Conductor (2) (Item 275, Appendix G) Splice, Conductor (Item 276, Appendix G) a. Removal. NOTE There are seven toggle switches on the WRECKER CONTROL PANEL. Steps (1 and 2) apply to all seven toggle switches. (1) Remove eight screws (1), lockwashers (2), and washers (3) from control panel top cover (4). Discard lockwashers. (2) Remove two self-locking nuts (5), four washers (6), two screws (7), and control panel top cover (4) from WRECKER CONTROL PANEL (8). Discard self-locking nuts. 7-202