TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 941 of 1396
TM 9-2320-366-20-3 b. Controller Installation. NOTE All four controllers are installed the same way. Boom Up/Down controller shown. (1) Install jam nut (1) on boom up/down controller (2). (2) Install knob (3) on boom up/down controller (2). (3) Tighten jam nut (1) against knob (3). WARNING Adhesives, solvents, and sealing com- pounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (4) Apply adhesive to seating surface (4). (5) Connect connector (5) to boom up/down controller (2). (6) Position boom up/down controller (2) in REMOTE CONTROL UNIT (6). (7) Apply adhesive to the first 2 to 5 threads of mounting studs (7). (8) Position four self-locking nuts (8) on boom up/down controller (2). (9) Tighten four self-locking nuts (8) to 14 lb-in. (2 N·m). NOTE Adhesive requires 24 hours to cure. (10) Spread excess adhesive over heads of four self-locking nuts (8). Change 1 7-191