TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 940 of 1396
TM 9-2320-366-20-3 7-32. REMOTE CONTROL UNIT REPAIR This task covers: a. Controller Removal b. Controller Installation c. Toggle Switch Removal d. Toggle Switch Installation e. Harness Removal f. Harness Installation g. Follow-On Maintenance INITIAL SETUP Equipment Conditions MHC remote control unit removed (TM 9-2320-366-10-1 or TM 9-2320-366-10-2). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-75 lb-in. (Item 90, Appendix B) Materials/Parts Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Adhesive (Item 5, Appendix D) Nut, Self-Locking (4) (Item 175, Appendix G) a. Controller Removal. NOTE All four controllers are removed the same way. Boom Up/Down controller shown. (1) Remove four self-locking nuts (1) from boom up/down controller (2). Discard self-locking nuts. (2) Remove boom up/down controller (2) from REMOTE CONTROL UNIT (3) until connector (4) is accessible. (3) Disconnect connector (4) from boom up/down controller (2). (4) Remove adhesive from seating surface (5). (5) Loosen jam nut (6) on boom up/down controller (2). (6) Remove knob (7) from boom up/down controller (2). (7) Remove jam nut (6) from boom up/down controller (2). 7-190 Change 1