TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download

Page 764 of 1396

TM 9-2320-366-20-3 7-7. STARTING MOTOR REPLACEMENT (CONT) (5) Remove adhesive, nut (8), terminal lugs TL25 (9), TL46 (10), ground strap (11), and terminal lug TL53 (12) from starting motor terminal (13). (6) Position nut (8) on starting motor terminal (13). NOTE Perform step (7) on vehicles that have not had connector P81 removed. (7) Disconnect connector P81 (14) from starting motor connector (15). (8) Remove screw (16) from starting motor (17). Discard screw. WARNING Starting motor weighs approximately 60 lbs (27 kgs). Attach a suitable lifting device prior to removal. Failure to comply may result in injury to personnel or damage to equipment. NOTE Step (9) requires the aid of an assistant. (9) Remove two screws (18) and starting motor (17) from flywheel housing (19). Discard screws. (10) Remove gasket (20) from starting motor (17). Discard gasket. 7-28 Change 1