TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 745 of 1396
TM 9-2320-366-20-3 Change 2 7-9 (10) Apply electrical tape to terminal lug TL110 (17). (10.1) Remove self-locking nut (14) and washer (15) from voltage regulator (16). (11) Position terminal lug TL110 (17), washer (15), and self-locking nut (14) on voltage regulator (16). (12) Tighten self-locking nut (14) to 20-lb-in. (3 N • m). (13) Position dust boot (18) on terminal lug TL110 (17). (14) Remove self-locking nut (19) and washer (20) from voltage regulator (16). (15) Position terminal lug TL35 (21), washer (20), and self-locking nut (19) on voltage regulator (16). (16) Tighten self-locking nut (19) to 25 lb-in. (3 N • m). (17) Position dust boot (22) on terminal lug TL35 (21). (18) Remove self-locking nut (23), washer (24), and two washers (25) from alternator (3). (19) Position two washers (25) terminal lugs TL6 (26) and TL2 (27), washer (24), and self-locking nut (23) on alternator (3). (20) Tighten self-locking nut (23) to 80 lb-in. (9 N • m). (21) Position dust boot (28) on terminal lug TL2 (27). (22) Position clamp (29), washer (30), and screw (31) on alternator (3). (23) Tighten screw (31) to 80 lb-in. (9 N • m). NOTE • Perform step (10) if replacing alternator P/N N1506-1 (12420852) with alternator P/N N1509-1 (12422863). • Install plastic cable ties as required to terminal lug TL110 and tie wire away from alternator. NOTE Perform steps (10.1) through (13) on alternator P/N N1506-1 (12420852).