TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 73 of 1396
TM 9-2320-366-20-3 TM 9-2320-366-20-3 TM 9-2320-366-20-3 TM 9-2320-366-20-3 TM 9-2320-366-20-3 2-2043 2-2043 2-2043 2-2043 2-2043 NOTE TIRE PRESSURE MEASUREMENT CAUTION WARNING When RUN FLAT has been selected to perform a troubleshooting step, be sure to press RUN FLAT again when step is completed to terminate CTIS operation and prevent excessive air loss. Four mode lights flashing indicate CTIS has shut off due to uneven tire pressure (one tire 50 percent less than other pressures will do it), tire damage, or major leak. Operator can continue CTIS operation by pressing RUN FLAT on CTIS ECU. When RUN FLAT has been selected CTIS ECU checks pressures at 15 second intervals. Wear appropriate eye protection when working under vehicle and around CTIS due to the possibility of falling or blown debris. Failure to comply may result in injury to personnel. (1) Measure and record the tire pressure of each tire (TM 9-2320-366-10-1). (2) If any tire pressure is lower than the rest, visually inspect tire for damage. (3) Apply soapy water solution to tire bead. (4) Observe tire for bubbles indicating leaks.