TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 723 of 1396
TM 9-2320-366-20-3 (9) Loosen two screws (12) in clamps (13) as far as possible without disengaging screws from D-nuts (14). (10) Unhook clamp tabs (15) from tab windows (16). CAUTION • Clamp tongue must be started in clamp groove. Failure to comply may result in damage to equipment. • Position clamps with screw heads facing forward so they do not interfere with alternator mount. (11) Position coolant hose (17) on water pump (3). (12) Position two clamps (13) on coolant hose (17). (13) Engage as many clamp tabs (15) as possible in tab windows (16) allowing little or no play between clamp and coolant hose (17). (14) Tighten two clamps (13) to 13-17 lb-in. (2 N·m). NOTE Minimum allowable gap on clamp is 0.2 in. (5 mm). If gap is less than 0.2 in. (5 mm), remove and re-install clamp. (15) Measure gap on two clamps (13). (16) Install preformed packing (18) and 45-degree fitting (19) in water pump (3). (17) Connect heater supply tube (20) to 45-degree fitting (3). Change 1 6-67