TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 713 of 1396
TM 9-2320-366-20-3 CAUTION • Clamp tongue must be started in clamp groove. Failure to comply may result in damage to equipment. • Position clamps so that screws will be toward center of vehicle and angled down. (3) Position two clamps (2) on lower coolant hose (6). (4) Install lower coolant hose (6) between radiator (7) and transmission oil cooler (8). (5) Engage as many clamp tabs (4) as possible in tab windows (5) allowing little or no play between clamp and lower coolant hose (6). (6) Tighten two clamps (2) to 12-18 lb-in. (1-2 N·m). NOTE Minimum allowable gap on clamp is 0.2 in. (0.5 cm). If gap is less than 0.2 in. (0.5 cm), remove and re-install clamp. (7) Measure gap on two clamps (2). 6-57