Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download

Page 633 of 1396

TM 9-2320-366-20-3 4-22. CHECKING AND STENCILING HIGH/LOW HAND THROTTLE POSITIONS This task covers: a. Checking High/Low Hand Throttle Positions b. Stenciling High/Low Hand Throttle Positions Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools STE/ICE-R (Item 41, Appendix C) Gloves, Rubber (Item 13, Appendix C) Respirator, Air Filter (Item 29, Appendix C) Materials/Parts Rubber Stamp Set, Fixed Type (Item 53, Appendix D) Polyurethane Coating (Item 48, Appendix D) Ink, Marking Stencil (Item 26, Appendix D) Inking Pad, Rubber Stamp (Item 27, Appendix D) References TM 9-4910-571-12&P TB 43-0209 a. Checking High/Low Hand Throttle Positions. (1) Connect STE/ICE-R to DCA connector (1). (2) Start engine (TM 9-2320-366-10-1). (3) Position HAND THROTTLE lever (2) so that upper edge of lever is even with line below L setting. NOTE Acceptable engine RPM with HAND THROTTLE lever at L setting is 1250-1450 RPM. (4) Perform STE/ICE-R test #10. 4-103