TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 632 of 1396
TM 9-2320-366-20-3 4-21. ACCELERATOR PEDAL REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C) Socket Set, Socket Wrench (Item 35, Appendix C) Materials/Parts Grease, Molybdenum Disulfide (Item 24, Appendix D) a. Removal. (1) Remove clip ring (1) from ball seat (2). (2) Remove ball seat (2) and threaded rod (3) from ball stud (4). (3) Remove two screws (6), washers (7), and accelerator pedal (5) from cab floor (8). b. Installation. (1) Position accelerator pedal (5) on cab floor (8) with two washers (7) and screws (6). (2) Tighten two screws (6) to 72-84 lb-in. (8-10 N·m). (3) Apply grease to inside of ball seat (2). (4) Install ball seat (2) and threaded rod (3) on ball stud (4). (5) Install clip ring (1) on ball seat (2). c. Follow-On Maintenance. (1) Start engine (TM 9-2320-366-10-1). (2) Depress accelerator pedal and check for smooth operation. (3) Shut down engine (TM 9-2320-366-10-1). End of Task. 4-102