TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 619 of 1396
TM 9-2320-366-20-3 4-18. THROTTLE CONTROL CABLE REPLACEMENT/ADJUSTMENT This task covers: a. Removal b. Installation c. Adjustment d. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine shut down (TM 9-2320-366-10-1). Steering wheel removed (para 13-2). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Materials/Parts Grease, Molybdenum Disulfide (Item 24, Appendix D) Personnel Required (2) a. Removal. (1) Position master power switch to on (TM 9-2320-366-10- 1). (2) Place wiper blades in the full left position (TM 9-2320- 366-10-1). (3) Position master power switch to off (TM 9-2320-366-10- 1). (4) Disconnect batteries (para 7-57). (5) Remove instrument panel assembly for access (para 7- 15). WARNING Retaining rings are under tension and can act as projectiles when released causing severe eye injury. Use care when removing retaining rings. Failure to comply may result in injury to personnel. (6) Remove retaining ring (1) and bellcrank (2) from stud (3). 4-89