TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 572 of 1396
TM 9-2320-366-20-3 4-8. FUEL TANK AND BRACKETS REPLACEMENT This task covers: a. Removal b. Installation c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Batteries disconnected (para 7-57). Tools and Special Tools Tool Kit, Genl Mech (Item 46, Appendix C) Container (60 Gal (227 L) capacity) Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C) Wrench, Torque, 0-600 lb-ft (Item 60, Appendix C) Socket Set, Impact (Item 33, Appendix C) Wrench, Torque. 0-200 lb-in. (Item 59, Appendix C) Materials/Parts Rag, Wiping (Item 50, Appendix D) Dispenser, Pressure Sensitive Adhesive Tape (Item 20, Appendix D) Ties, Cable, Plastic (Item 69, Appendix D) Sealing Compound (Item 56, Appendix D) Primer, Sealing Compound (Item 49, Appendix D) Packing, Preformed (Item 216, Appendix G) Nut, Self-Locking (2) (Item 156, Appendix G) Nut, Self-Locking (8) (Item 161, Appendix G) Personnel Required (2) WARNING Diesel fuel is flammable. If fuel is spilled, clean it up immediately. Failure to comply may result in serious injury or death to personnel. a. Removal. NOTE Remove plastic cable ties as required. (1) Disconnect connector clamp (1) from fuel level sending unit connector (2). (2) Disconnect fuel level sending unit connector (2) from connector P82 (3). (3) Position container under fuel tank (4). (4) Remove drain plug (5) from fuel tank (4) and drain fuel. 4-42 Change 1