TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 504 of 1396
TM 9-2320-366-20-3 2-46. GENERAL ASSEMBLY INSTRUCTIONS (CONT) h. Gaskets. Remove all traces of previous gasket and sealant before installing new gasket. Coat both sides of gasket with sealant to provide added sealing. 2-47. GENERAL INSTALLATION INSTRUCTIONS a. Preparation. When unpacking items, remove all packing material, barrier paper, tape, plastic bags, protective caps and protective grease coatings. Handle and store removed components carefully. CAUTION Use sealing compound sparingly and only on threads. Do not apply compound to hose connections. Failure to comply may result in damage to equipment. b. Sealing Compounds. Use only the sealing compounds specified in each maintenance task. c. Torquing. Tighten bolts, screws, nuts, and fittings as required in each maintenance task or in Appendix F. d. Identification Tags. Put hoses, tubes, lines, and electrical wiring in place by matching identification tags and markings on equipment. e. Hoses, Air Lines and Wiring. After installing hoses, air lines and wiring, ensure that they do not contact moving parts or component edges. Secure in place, out of the way, with cable ties and cushion clamps. f. Data Plate Installation. Install data plate on vehicle with rivets. g. Rivnut Installation. Install rivnut on vehicle with rivets. 2-48. PREPARATION FOR STORAGE OR SHIPMENT INTRODUCTION a. This section gives instructions for making the vehicle ready for shipment or storage. b. Refer to AR 750-1 for detailed administrative storage instructions. c. Refer to TB 9-2300-422-20 for security procedures. 2-49. PREPARATION FOR STORAGE OR SHIPMENT a. Perform Preventive Maintenance Checks and Services (PMCS) listed in Table 2-1. b. Correct all deficiencies noted during inspection, if facilities are available. If repairs are required, beyond the scope of Unit Maintenance, refer the deficiencies to Direct Support or General Support Maintenance. 2-2448