TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 485 of 1396
Stinger In Stinger Out Underlift Up Underlift Down Main Winch LH In Main Winch LH Out Main Winch RH In Main Winch RH Out Up Down In Out Down Up In Out In Out Underlift Fold Down Underlift Fold Up L18 L15 L16 L13 L14 L11 L6 L5 L2 L1 Lower Front Lower Rear Lower Front Lower Rear Lower Front Lower Rear Upper Front Lower Front Upper Rear Lower Rear AIR PRESSURE TEST STE/ICE-R TEST #50 Tag air hose and connection point prior to disconnecting. NOTE Wear protective goggles to protect against possible injury from release of high pressure air. Failure to comply may result in injury to personnel. WARNING TM 9-2320-366-20-3 Change 1 2-2432.1 Wrecker Remote Control Switch Position Actuator and Solenoid Valve Function Table 2-66. Wrecker Function Solenoid Valves and Actuators (1) Disconnect air hose from solenoid valve listed in Table 2-66. Wrecker Function Solenoid Valves and Actuators. (2) Install test adapter on solenoid valve. (3) Install STE/ICE-R 0-1000 psi transducer on test adapter. (4) Start engine (TM 9-2320-366-10-1). (5) Position WRECKER REMOTE CONTROL switch listed in Table 2-66. Wrecker Function Solenoid Valve. (6) Perform STE/ICE-R Test #50 and note reading on STE/ICE-R. (7) If 75 to 120 psi (517 to 827 kPa) is not present, notify DS Maintenance. (8) Shut down engine (TM 9-2320-366-10-1). (9) Drain air tanks (TM 9-2320-366-10-1). (10) Remove STE/ICE-R and test adapter from solenoid valve. (11) Install air hose on solenoid valve. Upper or Lower Valve Actuator Air Hose Position