TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download

Page 479 of 1396

Wear protective goggles to protect against possible injury from release of high pressure air. Failure to comply may result in injury to personnel. WARNING Wear protective goggles to protect against possible injury from release of high pressure air. Failure to comply may result in injury to personnel. WARNING AIR PRESSURE TEST NOTE Change 1 2-2430.5 Air pressure trapped in wrecker air system will be released when disconnecting M1089 30K winch pneumatic test adapter from solenoid port 1. (9) Disconnect M1089 30K winch pneumatic test adapter from pneumatic manifold (refer to Table 2-65.2. 30K Winch Pneumatic Manifold Drum Tensioner Solenoids) solenoid port 1. (10) Connect air hose to pneumatic manifold (refer to Table 2-65.2. 30K Winch Pneumatic Manifold Drum Tensioner Solenoids) solenoid port 1. (11) Install tube nipple on M1089 30K winch pneumatic test adapter. TM 9-2320-366-20-3 Side Table 2-65.2. 30K Winch Pneumatic Manifold Drum Tensioner Solenoids Solenoid LH RH L4 L8 (1) Disconnect air hose from pneumatic manifold (refer to Table 2-65.2. 30K Winch Pneumatic Manifold Drum Tensioner Solenoids) solenoid port 1. (2) Remove tube nipple from M1089 30K winch pneumatic test adapter. (3) Connect M1089 30K winch pneumatic test adapter to pneumatic manifold (refer to Table 2-65.2. 30K Winch Pneumatic Manifold Drum Tensioner Solenoids) solenoid port 1. (4) Start engine (TM 9-2320-366-10-1) and allow vehicle to build air pressure. (5) Perform STE/ICE-R Test #50 and note reading on STE/ICE-R. (6) If 75-120 PSI (518-827 kPa) is not present, repair M1089 30K winch pneumatic manifold solenoid or replace solenoid (refer to Table 2-65.2. 30K Winch Pneumatic Manifold Drum Tensioner Solenoids) (para 17-29). (7) Shut down engine (TM 9-2320-366-10-1). (8) Drain air tanks (TM9-2320-366-10-1).