TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 471 of 1396
NOTE WARNING Wear protective goggles to protect against possible injury from release of high pressure air. Failure to comply may result in injury to personnel. AIR PRESSURE TEST STE/ICE-R TEST #50 (12) Disconnect M1089 30K winch test adapter from input fitting. (13) Connect air hose to input fitting on M1089 30K winch manifold assembly. (14) Close LH and RH catwalks. (15) Install wrecker control panel top cover (para 14-4). (1) Connect M1089 30K winch test adapter to input fitting. (2) Connect air hose to M1089 30K winch test adapter. (3) Install STE/ICE-R 0-1000 PSI transducer in M1089 30K winch test adapter. (4) Start engine (TM9-2320-366-10-1) and allow vehicle to build air pressure. (5) Perform STE/ICE-R Test #50 and note reading on STE/ICE-R. (6) If 75-120 PSI (518-827 kPa) is not present, notify DS Maintenance to repair or replace M1089 30K winch manifold assembly. (7) If 75-120 PSI (518-827 kPa) is present, repair or replace M1089 30K winch pneumatic manifold assembly (para 17-29). (8) Shut down engine (TM 902320-366-10-1). (9) Drain air tanks (TM9-2320-366-10-1). (10) Remove STE/ICE-R 0-1000 PSI transducer from M1089 30K winch test adapter. (11) Disconnect air hose from M1089 30K winch test adapter. TM 9-2320-366-20-3 Change 1 2-2428.7 Tag air hose and connection point prior to disconnecting