TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 467 of 1396
AIR PRESSURE TEST STE/ICE-R TEST #50 NOTE Wear protective goggles to protect against possible injury from release of high pressure air. Failure to comply may result in injury to personnel. WARNING NOTE (1) Remove STE/ICE-R 0-1000 PSI transducer from M1089 30K winch pneumatic tester. (2) Connect M1089 30K winch test adapter to input tee fitting. (3) Install STE/ICE-R 0-1000 PSI transducer in M1089 30K winch test adapter. (4) Connect input air hose to M1089 30K winch test adapter. (5) Disconnect air hose from input tee fitting. (6) Remove tube nipple from M1089 30K winch pneumatic test adapter. (7) Connect M1089 30K winch pneumatic test adapter to input tee fitting. Apply antiseizing tape to first two to five threads of plug prior to installation. (8) Install plug in M1089 30K winch pneumatic test adapter. (9) Start engine (TM9-2320-366-10-1) and allow vehicle to build air pressure. (10) Perform STE/ICE-R Test #50 and note reading on STE/ICE-R. (11) If 75-120 PSI (518-827 kPa) is not present, repair or replace M1089 30K winch pneumatic manifold (para 17-29). (12) Shut down engine (TM 902320-366-10-1). (13) Drain air tanks (TM9-2320-366-10-1). (14) Remove plug from M1089 30K winch pneumatic test adapter. (15) Disconnect M1089 30K winch pneumatic test adapter from input tee fitting. (16) Install tube nipple on 30K winch pneumatic test adapter. (17) Connect air hose to input tee fitting. (18) Disconnect input air hose from M1089 30K winch test adapter. (19) Remove STE/ICE-R 0-1000 PSI transducer from M1089 30K winch test adapter. (20) Disconnect M1089 30K winch test adapter from input tee fitting. (21) Connect input air hose to input tee fitting. TM 9-2320-366-20-3 Change 1 2-2428.3 Tag air hose and connection point prior to disconnecting