TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 465 of 1396
AIR PRESSURE TEST STE/ICE-R TEST #50 NOTE WARNING Wear protective goggles to protect against possible injury from release of high pressure air. Failure to comply may result in injury to personnel. (1) Open LH and RH catwalks. (2) Disconnect input air hose from input tee fitting on pressure regulator. (3) Connect input air hose to M1089 30K winch pneumatic test adapter. (4) Install STE/ICE-R 0-1000 PSI transducer on M1089 30K winch pneumatic test adapter. (5) Start engine (TM 9-2320-366-10-1). (6) Perform STE/ICE-R Test #50 and note reading on STE/ICE-R. (7) If 75-120 PSI (518-827 kPa) is not present, go to step 5 of this fault. (8) Shut down engine (TM 9-2320-366-10-1). (9) Drain air tanks (TM 9-2320-366-10-1). (10) Disconnect input air hose from M1089 30K winch pneumatic test adapter. TM 9-2320-366-20-3 Change 1 2-2428.1 Tag air hose and connection point prior to disconnecting