TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download
Page 329 of 1396
TM 9-2320-366-20-3 TM 9-2320-366-20-3 TM 9-2320-366-20-3 TM 9-2320-366-20-3 TM 9-2320-366-20-3 2-2257 2-2257 2-2257 2-2257 2-2257 PRESSURE TEST WARNING NOTE Fuel and oil are slippery and can cause falls. Wipe up spilled fuel or oil with rags. Failure to comply may result in injury to personnel. Wear approved eye protection when performing pressure checks. Failure to comply may result in oil getting into eyes. If oil contacts eyes, seek medical attention immediately. Tee and adapter used in STE/ICE test are: (a) 3/4'' swivel nut run tee. (b) Internal pipe 1/2" F/ 37 degree flair 3/4"F swivel adapter. (1) Place drain pan under vehicle. (2) Disconnect hydraulic pressure hose from upper main pressure tube. Drop hydraulic pressure to zero before disconnecting any hydraulic hoses, tubes, and fittings. Failure to comply may result in injury to personnel. (3) Connect STE/ICE-R, with adapter and tee between hydraulic pressure hose and tube. (4) Start engine (TM 9-2320-366-10-1). (5) Position PTO switch to on (TM 9-2320-366-10-1). (6) Perform STE/ICE-R test #51 (TM 9-4910-571-12&P) and note pressure reading is between 2400-3000 psi (16,548- 20,685 kPa). (7) If pressure noted in step (6) is below 2400 psi (16,548 kPa), notify DS Maintenance. (8) If pressure noted in step (6) is between 2400-3000 psi (16,548-20,685 kPa), notify DS Maintenance. (9) Position PTO switch to off (TM 9-2320-366-10-1). (10) Shut down engine (TM 9-2320-366-10-1). (11) Disconnect STE/ICE-R test equipment, adapter and tee from hydraulic pressure hose. (12) Connect hydraulic pressure hose to upper main pressure tube valve. (13) Tighten hydraulic tube fitting to 36-39 lb-ft (49-53 N·m). (14) Remove drain pan from under vehicle.