TM-9-2320-366-20-3 MTV Unit Maintenance Manual M1083 Series - Volume 3 Download

Page 1093 of 1396

TM 9-2320-366-20-3 (5) Lift dust boot (10) on terminal lug TL60 (11). (6) Remove self-locking nut (12), washer (13), insulation washer (14), and terminal lug TL60 (11) from alternator (15). Discard self-locking nut. (7) Remove dust boot (10) from 100 amp alternator to reverse polarity relay 12 vdc cable (16). (8) Remove three screws (17), washers (18), clamps (19), and 100 amp alternator to reverse polarity relay 12 vdc cable (16) from engine (20). (9) Remove three clamps (19) from 100 amp alternator to reverse polarity relay 12 vdc cable (16). b. Installation. (1) Install three clamps (1) on 100 amp alternator to reverse polarity relay 12 vdc cable (2). NOTE Install plastic cable ties as required. (2) Position 100 amp alternator to reverse polarity relay 12 vdc cable (2) on engine (3) with three clamps (1), washers (4), and screws (5). (3) Tighten three screws (5) to 22-27 lb-ft (31-37 N·m). Change 1 7-337