TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 985 of 1632
Change 1 2-1741 TM 9-2320-366-20-2 RESISTANCE TEST 754-820 ohms 691-754 ohms 889-962 ohms 820-889 ohms 962-1039 ohms 1039-1118 ohms 1118-1202 ohms 1202-1286 ohms 122° to 140°F (50° to 60°C) 86° to 104°F (30° to 40°C) 104° to 122°F (40° to 50°C) 68° to 86°F (20° to 30°C) 50° to 68°F (10° to 20°C) 32° to 50°F (0° to 10°C) 14° to 32°F (-10° to 0°C) -4° to 14°F (-20° to -10°C) Temperature Resistance Table 2-34. Transmission Sump Oil Temperature Sensor Resistance Readings (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P119a. NOTE Transmission sump oil temperature sensor resistance reading is affected by temperature. Refer to Table 2-34. Transmission Sump Oil Temperature Sensor Resistance Readings for details. (3) Connect negative (-) probe of multimeter to connector P119d and note reading on multimeter. (4) Connect negative (-) probe of multimeter to all other pins in connector P119, one at a time, and note reading on multimeter. (5) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (6) Connect positive (+) probe of multimeter to connector P119d. (7) Connect negative (-) probe of multimeter to all other pins in connector P119 (except P119a), one at a time, and note reading on multimeter. (8) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (9) If correct resistance is not present in step 3, or continuity is present in step 4, 5, 7, or 8, notify DS Maintenance. (10) If correct resistance is present in step 3 and continuity is not present in step 4, 5, 7, or 8, replace WTEC III transmission ECU (para 8-7). (11) Connect connector P119 to connector J119. (12) Position front grille on cab with washer and screw. (13) Position two washers and screws in front grille. (14) Tighten screw to 48-60 lb-in. (5-7 N·m). (15) Tighten two screws to 24 lb-in. (3 N·m). (16) Clear diagnostic codes (para 8-5).