TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 953 of 1632
Prolonged contact with lubricating oil (MIL-L-2104) may cause a skin rash. Skin and clothing that come in contact with lubricating oil should be thoroughly washed immediately. Saturated clothing should be removed immediately. Areas in which lubricating oil is used should be well ventilated to keep fumes to a minimum. Failure to comply may result in injury to personnel. PRESSURE TEST WARNING (14) Disconnect flexible hose assembly from street elbow. (15) Remove street elbow from transmission oil cooler hose. (16) Install 45 degree fitting on transmission oil cooler hose. (17) Connect transmission oil sampling hose to 45 degree fitting. (18) Remove drain pan from under oil cooler hose. NOTE (1) Place drain pan under transmission oil cooler hose. (2) Disconnect transmission oil sampling hose from 45 degree fitting. Note orientation of 45 degree fitting prior to removal. (3) Remove 45 degree fitting from transmission oil cooler hose. (4) Install street elbow on transmission oil cooler hose. (5) Connect flexible hose assembly to street elbow. (6) Install reducer fitting on flexible hose assembly. (7) Install STE/ICE-R 0-1000 PSI transducer on reducer fitting. (8) Start engine (TM 9-2320-366-10-1). (9) Perform STE/ICE-R Test # 50 and note reading on STE/ICE-R. (10) If pressure is less than 10 PSI, notify DS Maintenance. (11) Shut down engine (TM 9-2320-366-10-1). (12) Remove STE/ICE-R 0-1000 PSI transducer from reducer fitting. (13) Remove reducer fitting from flexible hose assembly. Change 1 2-1711 TM 9-2320-366-20-2