TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 951 of 1632
PRESSURE TEST Prolonged contact with lubricating oil (MIL-L-2104) may cause a skin rash. Skin and clothing that come in contact with lubricating oil should be thoroughly washed immediately. Saturated clothing should be removed immediately. Areas in which lubricating oil is used should be well ventilated to keep fumes to a minimum. Failure to comply may result in injury to personnel. WARNING NOTE (13) Install preformed packing on 45 degree fitting. (14) Install 45 degree fitting in transmission oil cooler tube. (15) Connect transmission oil sampling hose to 45 degree fitting. (16) Remove drain pan from under oil cooler tube. (1) Place drain pan under transmission oil cooler tube. (2) Disconnect transmission oil sampling hose from 45 degree fitting. Note orientation of 45 degree fitting prior to removal. (3) Remove 45 degree fitting from transmission oil cooler tube. (4) Remove preformed packing from 45 degree fitting. Discard preformed packing. (5) Install adapter fitting in transmission oil cooler tube. (6) Install STE/ICE-R 0-1000 PSI transducer in adapter fitting. (7) Start engine (TM 9-2320-366-10-1). (8) Perform STE/ICE-R Test # 50 and note reading on STE/ICE-R. (9) If pressure is less than 10 PSI, notify DS Maintenance. (10) Shut down engine (TM 9-2320-366-10-1). (11) Remove STE/ICE-R 0-1000 PSI transducer from adapter fitting. (12) Remove adapter fitting from transmission oil cooler tube. Change 1 2-1710.3 TM 9-2320-366-20-2