Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download

Page 937 of 1632

CAUTION CONTINUITY TEST NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. (1) Disconnect batteries (para 7-57). (2) Remove PDP cover (para 16-2). (3) Remove three screws from PDP. (4) Remove three screws and washers from PDP. (5) Lift PDP outward to gain access. (6) Set multimeter to ohms. (7) Connect positive (+) probe of multimeter to connector PX33 socket C1. (8) Connect negative (-) probe of multimeter to terminal board TB1 position 60 and not reading on multimeter. (9) If continuity is not present, Repair wire 1460 from connector PX33 sockets C1 to terminal board TB1 position 60 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10). (10) Connect connector PX33 to WTEC II VIM. (11) Tighten screw in connector PX33. (12) Install kick panel (para 16-3). TM 9-2320-366-20-2 Change 1 2-1706.35