TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 935 of 1632
CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector J116 socket A2. (3) Connect negative (-) probe of multimeter to connector J115 socket 18 and note reading on multimeter. (4) If continuity is not present, replace WTEC II cab transmission harness (para 7-137). (5) If continuity is present, replace WTEC II TEPSS (para 8-2). (6) Connect connector J116 to WTEC II VIM connector. (7) Tighten screw in connector J116. (8) Install kick panel (para 16-3). TM 9-2320-366-20-2 Change 1 2-1706.33