TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 925 of 1632
CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST (1) Loosen screw in connector J116. (2) Disconnect connector J116 from WTEC II VIM. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to WTEC II connector pin J1. (5) Connect negative (-) probe of multimeter to WTEC II connector pin R1 and note reading on multimeter. (6) If continuity is not present, go to step 12 of this fault. TM 9-2320-366-20-2 Change 1 2-1706.23