TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 923 of 1632
CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST (1) Disconnect batteries (para 7-57). (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to connector PX33 socket K1. (4) Connect negative (-) probe of multimeter to connector PX33 socket K2 and note reading on multimeter. (5) If continuity is not present, Repair wires 3101 and 3102 from connector PX33 sockets K1 and K2 to terminal board TB2 position 16 and 17 (para 2-45) or replace WTEC II dashboard cable assembly (para 7-10). TM 9-2320-366-20-2 Change 1 2-1706.21