TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 899 of 1632
VOLTAGE TEST (1) Remove instrument panel assembly for access (para 7-15). (2) Start engine (TM 9-2320-366-10-1). (3) Set multimeter to volts DC. (4) Disconnect connector J115 (top connector) from WTEC II TEPSS. (5) Connect positive (+) probe of multimeter to connector J115-2. (6) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (7) Connect positive (+) probe of multimeter to connector J115-11. (8) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (9) If 12 to 14.5 VDC is not present at connector J115-2 and J115-11, replace WTEC II cab transmission harness (para 7-137). (10) Shut down engine (TM 9-2320-366-10-1). Change 1 2-1703 TM 9-2320-366-20-2