TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 887 of 1632
TM 9-2320-366-20-2 Change 1 2-1691 Sub Code Sub Code Meaning Pressure Readings C3 Tap 17 27 80 87 97 215-276 psi (1480-1900 kPa) 1-R 2-R N1-L N1-R 2-R Shift Shift Shift Shift Shift Table 2-32. Clutch Pressure Tap 215-276 psi (1480-1900 kPa) 215-276 psi (1480-1900 kPa) 215-276 psi (1480-1900 kPa) 215-276 psi (1480-1900 kPa) PRESSURE TEST (1) Remove front and intermediate propeller shafts (para 9-2). (2) Position drain pan under C3 pressure tap. (3) Remove C3 pressure tap plug and preformed packing from control valve module. (4) Connect tube to boss adapter, hose, and pipe to tube adapter to C3 pressure tap. (5) Perform STE/ICE-R test # 50 (TM 9-4910- 571-12&P). (6) Start engine (TM 9-2320-366-10-1) and run at idle. (7) With parking brake applied, make shift indicated by sub code while assistant notes reading on STE/ICE-R. Refer to Table 2-32. Clutch Pressure Tap. (8) Shut down engine (TM 9-2320-366-10-1). (9) If 215-276 psi pressure is not obtained for affected code, notify DS Maintenance. (10) If 215-276 psi pressure is obtained, replace WTEC II TEPSS (para 8-2). (11) Remove pipe to tube adapter, hose, and tube to boss adapter from C3 pressure tap. (12) Position preformed packing and C3 pressure tap plug in control valve module. (13) Tighten C3 pressure tap plug to 84-120 lb-in. (9-14 N·m). (14) Remove drain pan under pressure tap. (15) Install front and intermediate propeller shafts (para 9-2). (16) Clear diagnostic codes (para 8-4).