TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 859 of 1632
CONTINUITY TEST TM 9-2320-366-20-2 Table 2-27. WTEC II Cab Transmission Harness Continuity Check Column 2 Positive (+) Probe to: Column 1 Jumper Across: COLUMN 3 Negative (-) probe to: J115-22 J114-24 J114-24 J115-22 J115-1 J115-1 J119Z to J119R (9) If continuity is not present on any wire in Table 2-27. WTEC II Cab Transmission Harness Continuity Check, replace WTEC II cab transmission harness (para 7-137). (10) Remove jumper wire from connector J119. J119f to J119Z J119f to J119R (1) Lower cab (TM 9-2320-366-10-1). (2) Remove two screws and washers from front grille. (3) Remove screw and washer from front grille. (4) Remove front grille from cab. (5) Remove instrument panel assembly for access (para 7-15). (6) Disconnect connector J114 (bottom connector) at WTEC II TEPSS. (7) Set multimeter to ohms. (8) For each line of Table 2-27. WTEC II Cab Transmission Harness Continuity Check: (a) Install jumper wire across sockets in column 1. (b) Connect positive (+) probe of multimeter to socket in column 2. (c) Connect negative (-) probe of multimeter to socket in column 3 and note reading on multimeter. Change 2 2-1665