TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 825 of 1632
CONTINUITY TEST Change 1 2-1631 TM 9-2320-366-20-2 (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector J119. Refer to Table 2-24. Main Code 43 Sub Code 21 and 26 Low Side Test Points. (3) Connect negative (-) probe of multimeter to connector J114 and note reading on multimeter. Refer to Table 2-24. Main Code 43 Sub Code 21 and 26 Low Side Test Points. (4) Connect negative (-) probe of multimeter to all other sockets in connector J114, one at a time, and note reading on multimeter. (5) Connect negative (-) probe of multimeter to all sockets in connector J115, one at a time, and note reading on multimeter. (6) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (7) If continuity is not present in step 3, or continuity is present in step 4, 5, or 6, replace WTEC II cab transmission harness (para 7-137). Table 2-24. Main Code 43 Sub Code 21 and 26 Low Side Test Points Sub Code Connector J114 Connector J119 21 26 10 1 H A