TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 821 of 1632
Change 1 2-1627 TM 9-2320-366-20-2 Connector P119 Sub Code Positive (+) Probe Negative (-) Probe 12 13 14 15 16 21 22 23 24 26 P119M P119T P119C P119W P119U P119F P119D P119P P119J P119K P119B P119N P119V P119B P119N P119H P119V P119S P119B P119A Table 2-21. Connector P119 Transmission Solenoid Resistance Test Points Table 2-22. Transmission Solenoid Resistance Readings Resistance 4° to 16°F (-20° to -10°C) 16° to 32°F (-10° to 0°C) 32° to 50°F (0° to 10°C) 50° to 68°F (10° to 20°C) 68° to 86°F (20° to 30°C) 86° to 104°F (30° to 40°C) 104° to 122°F (40° to 50°C) 122° to 140°F (50° to 60°C) 2.50-3.12 ohms 2.62-3.25 ohms 2.74-3.38 ohms 2.86-3.50 ohms 2.98-3.62 ohms 3.09-3.75 ohms 3.21-3.88 ohms 3.33-4.00 ohms Temperature RESISTANCE TEST (1) Disconnect connector P119 from connector J119. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to connector P119. Refer to Table 2-21. Connector P119 Transmission Solenoid Resistance Test Points for appropriate sub code(s) and connector P119 pin(s). (4) Connect negative (-) probe of multimeter to connector P119 and note reading on multimeter. Refer to Table 2-21. Connector P119 Transmission Solenoid Resistance Test Points for appropriate sub code(s) and connector P119 pin(s). Transmission solenoid resistance is affected by temperature. Refer to Table 2-22. Transmission Solenoid Resistance Readings. (5) If resistance reading indicates transmission solenoid is good, replace WTEC II TEPSS (para 8-2). (6) If resistance reading indicates transmission solenoid is faulty, notify DS Maintenance. (7) Connect connector P119 to connector J119. (8) Position front grille on cab with washer and screw. (9) Position two washers and screws in front grille. (10) Tighten screw to 48-60 lb-in. (5-7 N·m). (11) Tighten two screws to 24 lb-in. (3 N·m). (12) Clear diagnostic codes (para 8-4). NOTE