TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 791 of 1632
CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. RESISTANCE TEST TM 9-2320-366-20-2 Change 1 2-1599 (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P119 pin p. (3) Connect negative (-) probe of multimeter to connector P119 pin r and note reading on multimeter. NOTE A good turbine speed sensor will return a reading of 200-400 ohms resistance as follows: a. 200 ohms at -40°F (-40°C). b. 300 ohms at 68°F (20°C). c. 400 ohms at 230°F (110°C). (4) Connect negative (-) probe of multimeter to all other pins in connector P119 and note reading on multimeter. (5) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (6) If 200-400 ohms resistance is not present in step 4, or continuity is present in step 5 or step 6, notify DS Maintenance. (7) If 200-400 ohms resistance is present in step 3, and continuity is not present in step 5 or step 6, replace WTEC II TEPSS (para 8-2). (8) Connect connector J115 to WTEC II TEPSS. (9) Install instrument panel assembly (para 7-15). (10) Connect connector P119 to connector J119. (11) Position front grille on cab with washer and screw. (12) Position two washers and screws in front grille. (13) Tighten screw to 48-60 lb-in. (5-7 N·m). (14) Tighten two screws to 24 lb-in. (3 N·m). (15) Clear diagnostic codes (para 8-4).