TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 785 of 1632
TM 9-2320-365-20-2 TM 9-2320-365-20-2 TM 9-2320-365-20-2 CONTINUITY TEST Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION (11) Position front grille on cab with washer and screw. (12) Position two washers and screws in front grille. (13) Tighten screw to 48-60 lb-in. (5-7 N·m). (14) Tighten two screws to 24 lb-in. (3 N·m). (15) Clear diagnostic codes (para 8-4). TM 9-2320-366-20-2 (1) Set multimeter to ohms position. (2) Connect positive (+) probe of multimeter to connector socket J115-16. (3) Connect negative (-) probe of multimeter to connector socket J119s and note reading on multimeter. (4) Connect negative (-) probe of multimeter to all other sockets in connector J119 and note reading on multimeter. (5) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (6) If continuity is not present in step 3, or continuity is present in step 4 or step 5, replace WTEC II cab transmission harness (para 7-137). (7) If continuity is present in step 3 and no shorts circuits are found, replace WTEC II TEPSS (para 8-2). (8) Connect connector J115 to WTEC II TEPSS. (9) Install instrument panel assembly (para 7-15). (10) Connect connector P119 to connector J119. Change 1 2-1593