TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 703 of 1632
TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 TM 9-2320-366-20-2 2-1511 2-1511 2-1511 2-1511 2-1511 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector J209-2. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, go to step 9 of this fault. (5) If continuity is present, replace transmission auxiliary oil cooler fan (para 8-19 or 8-21). (6) Connect connector J209 to transmission auxiliary oil cooler fan connector. (7) Install circuit breaker CB22 in PDP. (8) Install PDP cover (para 16-2). (1) Remove PDP cover (para 16-2). (2) Remove circuit breaker CB22 from PDP. (3) Disconnect connector J209 from transmission auxiliary oil cooler fan connector. (4) Set multimeter to volts dc. (5) Connect positive (+) probe of multimeter to connector J209-1. (6) Connect negative (-) probe of multimeter to ground. (7) Start engine (TM 9-2320-366-10-1) and note reading on multimeter. (8) If 24 vdc is not present, go to step 4 of this fault. (9) Shut down engine (TM 9-2320-366-10-1).