TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 687 of 1632
CONTINUITY TEST CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to DUMP BED UP/DOWN switch terminal 3. (3) Connect negative (-) probe of multimeter to DUMP BED UP/DOWN switch terminal 1. (4) Press and hold DUMP BED UP/DOWN switch to DOWN and note reading on multimeter. (5) If continuity is not present, replace DUMP BED UP/DOWN switch (para 7-18). (6) Release DUMP BED UP/DOWN switch. (7) Install circuit breaker CB50 in PDP. TM 9-2320-366-20-2 Change 1 2-1501