TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 673 of 1632
CONTINUITY TEST CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. (10) Connect batteries (para 7-57). (11) Lift dump body. (12) Place maintenance legs in stowed position. (13) Lower dump body. (14) Remove cargo sling from dump body lifting brackets. (15) Remove two dump body lifting brackets from dump body. (16) Position two locking pins in dump body. (17) Install safety pin in two locking pins. TM 9-2320-366-20-2 (1) Disconnect connector P172 from connector J172. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to connector P172 socket F. (4) Connect negative (-) probe of multimeter to connector P108 socket 6 and note reading on multimeter. (5) If continuity is not present, repair wire 2043 from connector P172 socket F to connector P108 socket 6 (para 2-45) or replace M1090/M1094 dump power cable assembly (para 7-125). (6) If continuity is present, repair wire 2043 from connector J172 Pin F to connector L8 socket 1 (para 2-45) or replace M1090/M1094 dump cable assembly (para 7-124). (7) Connect connector P172 to connector J172. (8) Connect connector P108 to connector J108. (9) Install kick panel (para 16-3). Change 1 2-1490.3