TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 67 of 1632
CONTINUITY TEST CONTINUITY TEST TM 9-2320-366-20-2 Change 2 2-958.15 (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P84 socket A. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3032 from connector P84 socket A to terminal lug TL85 (para 2-45) or replace start and charging cable assembly (para 7-132). (5) Connect connector P84 to air pressure switch. (1) Disconnect connector P110 from CTIS ECU. (2) Remove kick panel (para 16-3). (3) Disconnect connector P111 from connector J111. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to connector P111 pin F. (6) Connect negative (-) probe of multimeter to connector P110 socket T and note reading on multimeter. (7) If continuity is not present, replace CTIS cable assembly (para 7-60).