TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 667 of 1632
TM 9-2320-366-20-2 Change 1 2-1487 VOLTAGE TEST Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. WARNING (1) Connect connector L8 to solenoid valve. (2) Tighten screw in connector L8. (3) Remove six screws from auxiliary panel. (4) Lift auxiliary panel outward to gain access. (5) Remove PDP cover from PDP (para 16-2). (6) Remove circuit breaker CB50 from PDP. (7) Disconnect connector P911 from DUMP BED UP/DOWN switch connector. (8) Set multimeter to volts DC. (9) Connect positive (+) probe of multimeter to P911 socket 3. (10) Connect negative (-) probe of multimeter to ground. (11) Install circuit breaker CB50 in PDP and note reading on multimeter. (12) If 24 VDC is not present, go to step 9 of this fault. (13) Remove circuit breaker CB50 from PDP.