TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download

Page 663 of 1632

CAUTION CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector L8 socket 1. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, go to step 4 of this fault. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to terminal 1 on up solenoid. (3) Connect negative (-) probe of multimeter to terminal 2 on up solenoid and note reading on multimeter. (4) If continuity is not present, replace solenoid valve (para 7-142). (5) If continuity is present, notify DS Maintenance to perform Dump Body Hydraulic System troubleshooting task k1. Dump Body Does Not Raise. (6) Connect connector L8 to solenoid valve. (7) Tighten screw in connector L8. CONTINUITY TEST Change 2 2-1483 TM 9-2320-366-20-2