TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 655 of 1632
CONTINUITY TEST (1) Remove kick panel (para 16-3). (2) Disconnect connector P108 from connector J108. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to connector P910 socket 1. (5) Connect negative (-) probe of multimeter to connector J108 pin 8 and note reading on multimeter. (6) If continuity is not present, repair wire 2045 from connector P910 socket 1 to connector J108 pin 8 (para 2-45) or replace auxiliary panel cable assembly (para 7-58). (7) Connect connector P108 to connector J108. (8) Install kick panel (para 16-3). (9) Connect connector P910 to tailgate release switch. (10) Position auxiliary panel on auxiliary panel housing with six screws. (11) Tighten six screws to 24 lb-in. (3N.m). TM 9-2320-366-20-2 Change 1 2-1477 Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment.