TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 651 of 1632
VOLTAGE TEST (1) Remove six screws from auxiliary panel. (2) Lift auxiliary panel outward to gain access. (3) Disconnect connector P910 from tailgate release switch. (4) Set multimeter to volts DC. (5) Connect positive (+) probe of multimeter to connector P910 socket 3. (6) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (7) If 24 VDC is not present, repair wire 2006 from connector P910 socket 3 to connector P912 socket 1 (para 2-45) or replace auxiliary panel cable assembly (para 7-58). TM 9-2320-366-20-2 Change 1 2-1473 Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. WARNING