TM-9-2320-366-20-2 MTV Unit Maintenance Manual M1083 Series - Volume 2 Download
Page 647 of 1632
VOLTAGE TEST (1) Raise dump bed (TM 9-2320-366-10-1). (2) Loosen screw on connector L7. (3) Disconnect connector L7 from tailgate release solenoid. (4) Set multimeter to volts DC. (5) Connect positive (+) probe of multimeter to connector L7 socket 1. (6) Connect negative (-) probe of multimeter to ground. (7) Press and hold tailgate release switch (TM 9-2320-366-10-1) and note reading on multimeter. (8) If 24 VDC is not present, go to step 3 of this fault. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. Wear appropriate eye protection when working under vehicle due to the possibility of falling debris. Failure to comply may result in injury to personnel. Dump body weighs approximately 3,034 lbs (1,376 kgs). Attach a suitable lifting device prior to lifting. Failure to comply may result in injury to personnel or damage to equipment. TM 9-2320-366-20-2 Change 1 2-1469 WARNING